Commissioning - Continuous Operation; Switching Off Unit; Maintenance; Cleaning - Maico EAT 6 G/1 Notice De Montage Et Mode D'emploi

10. Commissioning – continuous
operation
 Move operating mode switch [2] into
"Continuous" position.
● Unit switches on. Fan runs at set minimum
speed.

11. Switching off unit

 Move operating mode switch [2] into "Off"
position.

12. Maintenance

The unit is maintenance-free.

13. Cleaning

 If dusty, clean the unit with a soft, dry cloth.
Do not use cleaning agents.

14. Fault rectification

● Call on the services of a qualified
electrician any time there is a fault!
● Repairs should only be carried out by a
qualified electrician!
Danger to life. Unit is powered
up!
 Switch the mains fuse off!
DANGER
Fault
In the event of a short
circuit or if cable to
temperature sensor is
interrupted, the fan
will run at minimum
speed. Red indicator
light [9] switches on.
Micro-fuse has
tripped.
Tab.1: Fault rectification
12
Measure
Call on the services of
a qualified electrician.
Call on the services of
a qualified electrician.

15. Dismantling

Dismantling should only be carried out by
a trained electrician.
16. Environmentally responsible
disposal
The unit and the packaging contain parts that
can be recycled, and should not end up in the
domestic waste. Dispose of the packaging
material in an environmentally-friendly way, in
compliance with the regulations valid in the
country where you are.
At the end of its service life, dispose of the
unit in an environmentally-friendly way, in
compliance with the regulations valid in the
country where you are.