LENCO HPW-400 Mode D'emploi page 5

 Do not overload ac outlets or extension cords. Overloading can cause
fire or electric shock.
 Devices with class 1 construction should be connected to a main socket
outlet with a protective earthed connection.
 Devices with class 2 construction do not require a earthed connection.
 Always hold the plug when pulling it out of the main supply socket. Do
not pull the power cord. This can cause a short circuit.
 Do not use a damaged power cord or plug or a loose outlet. Doing so
may result in fire or electric shock.
28. If the product contains or is delivered with a remote control containing
coin/cell batteries:
Warning:
 "Do not ingest battery, Chemical Burn Hazard" or equivalent working.
 [The remote control supplied with] This product contains a coin/button
cell battery. If the battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
 Keep new and used batteries away from children.
 If the battery compartment does not close securely, stop using the
product and keep it away from children.
 If you think batteries might have been swallowed or placed inside any
part of the body, seek immediate medical attention.
29. Caution about the use of Batteries:
 Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
 Battery cannot be subjected to high or low extreme temperatures, low
air pressure at high altitude during use, storage or transportation.
 Replacement of a battery with an incorrect type that can result in an
explosion or the leakage of flammable liquid or gas.
 Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion.
 Leaving a battery in an extremely high temperature surrounding
environment that can result in an explosion or that leakage of
flammable liquid or gas.
 A battery subjected to extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
 Attention should be drawn to the environmental aspects of battery
disposal.
INSTALLATION
• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the mains voltage and
before all other connections have been made.
5