LENCO HPW-400 Mode D'emploi page 14

4.2
To charge the headset:
1.
Via the base:
Slide the ON/OFF switch to the OFF position and
place the headset into the base to recharge the built-
in battery.
Status LED:
flashing green:
constant green:
It takes approximately 2 hours to fully charge an empty
battery, however for first time use it's
recommended to
the battery for 4 to 5 hours.
2.
To charge directly:
Slide the ON/OFF switch to the OFF
position and connect the power
adaptor to the USB port on the side
of the headset.
Only use the supplied power adaptor with type no. YLJXA-E050055.
Input 100-240VAC 0.5A / output 5.0VDC 550mA
while charging, the status LED will
be flashing in a green color
as soon as the battery is fully
charged, the green status LED will
remain permanently lit
continuously charge
14