Applications; Safety Notes - Monacor TXA-800PS Mode D'emploi

GB

1 Applications

This intelligent quick charging station is used
for charging the batteries of the units TXA-
800HSE (pocket transmitter) and TXA-800R
(pocket receiver). The batteries of up to two
units may be charged at the same time.
The charging station features a most con-
venient handling: To charge the batteries, they
do not need to be removed from the trans -
mitter or receiver; the unit is inserted into the
charging compartment together with its bat -
teries. The design of the charging compart-
ments will ensure correct insertion of the units,
thus preventing inadvertent reverse polarity.

2 Safety Notes

The units (charging station and plug-in power
supply unit) correspond to all required direc -
tives of the EU and are therefore marked with
.
Please observe the following items in any
case:
Only use this charging station for recharge-
G
able NiCd or NiMH batteries. If non-re -
chargeable batteries are charged, this may
result in leakage or even explosion!
Only insert rechargeable batteries of the
G
same type into the transmitter or the re ceiv -
er and always replace the batteries in pairs.
The units are suitable for indoor use only.
G
Protect them against dripping water and
splash water, high air humidity, and heat
(admissible ambient temperature range
0 – 40 °C).
Do not operate the charging station or im-
G
mediately disconnect the power supply unit
from the mains socket
6
WARNING: The plug-in power
supply unit uses dangerous
mains voltage (230 V~). Leave
servicing to skilled personnel
only. Inexpert handling may re-
sult in electric shock.
1. if the charging station or the power sup-
ply unit is visibly damaged,
2. if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3. if malfunctions occur.
In any case the charging station or the
power supply unit must be repaired by
skilled personnel.
For cleaning only use a dry, soft cloth;
G
never use chemicals or water.
No guarantee claims for the unit and no
G
liability for any resulting personal damage
or material damage will be accepted if the
charging station or the power supply unit is
used for other purposes than originally in-
tended, if it is not correctly connected or
operated, or not repaired in an expert way.
If the units are to be put out of oper -
ation definitively, take them to a local
recycling plant for a disposal which
is not harmful to the environment.
Defective rechargeable batteries do not
belong in the household rubbish; always
take them to a special waste disposal (e. g.
collection container at your retailer).
3 Operation
1) Connect the power supply unit provided to
the jack DC IN, located on the side of the
charging station, and to a mains socket
(230 V~/50 Hz). Thus, the charging station
is switched on.
2) After switching on, the charging station will
perform a short self-test: at each charging
compartment, the LEDs OK and ON will
shortly light up in succession. After com-
pletion of the self-test, the LEDs ON will
shortly light up once again: the charging
station is now ready for operation.
3) Insert the units (TXA-800HSE or TXA-
800R) with their batteries into the charging
compartments.