COFAN 0900 0913 Guide D'utilisation page 19

4. Instructions.
(1) Only those fasteners listed by the manufacturer shall be used fastener driving tools.
(2) Fastener driving tools equipped with contact actuation or continuous actuation with a safety
yoke may not be used:
(a) If changing one driving location to another involves the use of stairs, ladders or scaffolding.
(b) For closing boxes or crates.
(c) For fitting transportation safety systems
(3) For the maintenance of fastener driving tools, only spare parts specified by the manufacturer
or his authorized representative shall be used.
(4) Repairing shall be carried out only by agents authorized by the manufacturer or by other
specialists, having due regard to the information given in this operating instructions.
(5) Fixing for securing the fastener driving tools to a support, for example a work table, shall be
designed and constructed by the fixing manufacturer in such a way that the fastener driving
tools can be safely secured for the intended use, thus for example avoiding damage,
distortion or displacement.
(6) Fastener driving tools operated by compressed air shall only be connected to compressed
air lines where the maximum permissible operating pressure cannot be exceeded by a
factor of more than 10%.
(7) When using fastener driving tools operated by compressed air, care must be taken to ensure
that the maximum permissible operating pressure is not exceeded.
(8) Fastener driving tools operated by compressed air must not be operated using oxygen or
combustible gases under pressure.
(9) Fastener driving tools operated by compressed air shall only be operated at the lowest pres-
sure required for the work process at hand, in order to prevent unnecessarily high noise levels,
increased wear and resulting failures.
5. Explanations of Warning Signs Used For This Tool.
The operator's
Instruction must be read
before work starts.
Hearing protection
Must be worn.
ENGLISH
Eye protection must
be used or safety
glasses worn.
17
Safety yoke.