Trouble Shooting - Dexter 20VMT2-20.1 Mode D'emploi

7. TROUBLE SHOOTING

Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check
the product using this section. In most cases the problem can be solved quickly.
WARNING! Only perform the steps described within these instructions! All further
inspection, maintenance and repair work must be performed by an authorised service
centre or a similarly qualified specialist if you cannot solve the problem yourself!
Problems
1. Product does 1. 1. Bad connection to battery pack
not start 1. 2. The battery is not charged
2. Product does 2. 1. Power source (e.g. generator)
not reach full
power 2. 2. Air vents are blocked
3. Unsatisfactory 3. 1. Blade / sanding paper is dull/
result
3. 2. Blade not suitable for work
4. Excessive 4. 1. Blade is dull/damaged
vibration or
noise
STORAGE
1. Switch the product off and disconnect it from the power supply.
2. Clean the product as described above.
3. Store the product and its accessories in a dark, dry, frost-free, well-ventilated place.
4. Always store the product in a place that is inaccessible to children. The ideal storage temperature
is between 10°C and 30°C.
5. We recommend using the original package for storage or covering the product with a suitable
cloth or enclosure to protect it against dust.
TRANSPORT
1. Switch the product off and disconnect it from the power supply. Remove the drill bit / chisel if
applicable.
2. Protect the product from any heavy impact or strong vibrations which may occur during
transportation in vehicles.
3. Secure the product to prevent it from slipping or falling over.
Probable causes
has too low voltage
damaged
piece material
Corrective action
1. 1. Re-insert the battery pack
1. 2. Charge the battery
2. 1. Connect to another power
source
2. 2. Clean the air vents
3. 1. Replace with new one
3. 2. Use proper blade
4. 1. Replace with a new one
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO
RO
BR
BR
EN
EN
317