Operation - Dexter 20VMT2-20.1 Mode D'emploi

FR FR

5. OPERATION

ES ES
PT PT
IT IT
The declared vibration total values and the declared noise emission values have been measured in
accordance with a standard test method according to EN 62841-2-4 (sanding). They may be used
EL EL
for comparing one tool with another and in a preliminary assessment of exposure.
PL PL
WARNING! The vibration and noise emissions during actual use of the power tool can differ
from the declared values depending on the ways in which the tool is used especially what kind of
workpiece is processed.
RU RU
It is necessary to identify safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as
KZ UA
the times when the tool is switched off and when it is running idle in addition to the trigger time).
KZ UA
RO
RO
BR
BR
Tool attachments are available in various shapes and sizes. Below is only overview of some typical
EN
EN
tool attachments. Ask in store for more choices.
Tool attachments
Sanding base
plate & Sanding
paper
Plunge saw
blade
HSS segment
saw blade
312
WARNING!
Always wear ear protectors, when you are operating this machine.
WARNING! Always use blade according to the intended use!
Observe the technical requirements of this product (see Technical data) when purchasing
and using tool attachments accessories!
The tool holder and tool attachments can be very hot after not assemble/disassemble
them before cooling down!
Material
Bare or painted wood,
plaster, and other surface,
depending on grain size
(grit) of sanding paper
Wood, plastic,
drywall, soft metals
Wood, plastic, drywall,
nonferrous metals
Application
Flat sanding and reaching
into corners and along
edges.
Separating or flush/
plunge saw cutting,also
close to edges, corners
and reach areas.