Battery Installation; Programming The Timer; Manual Operation - AQUAJOE AJ-ET2Z Instructions D'origine

Battery Installation

1. Open the battery compartment on the
lower back of the timer.
2. Pull out the battery compartment and
insert two AA batteries (not included).
Secure the battery compartment back
into the unit (Fig. 1).
Fig. 1
Set Current Time
Refer to Fig. 2 for the following instructions.
1. Use the "+" button to increase time
displayed.
2. Use the "-" button to decrease time
displayed.
3. Make sure that correct AM/PM is
displayed.
Fig. 2
TIP : Holding "+" or "-" button down allows
you to scroll or more quickly through your
time selection.
Battery
Compartment

Programming the Timer

1. To set watering frequency, press the "S"
button to cycle through options.
Settings range from 1st to 7th. You may
set up 1st (once a day), 2nd (once every
two days), 3rd (once every three days),
etc (Fig. 3).
2. To select water cycle on dial, turn the
dial to select one of the 13 settings you
wish to run. For example, water at 6 AM
for 15, 30 or 60 minutes; water at 6 AM
and 6 PM for 15, 30 or 60 minutes; water
at 7 AM for 15, 30 or 60 minutes; and
water at 7 AM and 7 PM for 15, 30 or 60
minutes (Fig. 3).
Fig. 3
Installing the Timer
Attach timer securely to the faucet and hose.
Open the faucet and leave it open. Water
will turn on and shut off at the selected time.
Ensure cover is closed securely.

Manual Operation

To water for non-timed application, with the
water turned on at the faucet, turn the dial
to ON. Turn the dial to OFF to stop manual
watering (Fig. 4).
Fig. 4
Manual set
3
Preset
time
"S"
button