EUROM LO20 Manuel D'utilisation page 10

Masquer les pouces Voir aussi pour LO20:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Position
Excess moisture will travel throughout your home, in the same way that cooking smells
waft to every room in the house. For this reason, the dehumidifier should be positioned,
so that it can draw this moist air towards it from all over the home.
Alternatively, if you have a serious problem in one area you can begin by positioning the
dehumidifier close to this area and later moving it to a more central point.
When positioning the dehumidifier, ensure that it is placed on a level surface and that
there is a minimum of 10 cm (4") of space on either side of the unit to allow for efficient
airflow.
If you move the unit, it should first be switched off and the water tank emptied.
We do not recommend the use of an extension lead, so please try to ensure that the unit
is sufficiently close to a fixed mains socket. If it is necessary to use am extension lead,
use one with earthing and please ensure the diameter of the wires of the cable is at least
1,5 mm2.
Don't place the device near a heater, stove or other heat source, and not in full sunshine.
When the dehumidifier is in operation, outside doors and windows should be closed
when necessary for most efficient use. However, do not use the device in a sealed or
very small space.
Operation
1. Plug the unit into a correct mains socket. Please refer to the rating label for correct
voltage/frequency. Only connect the equipment to an earthed socket.
2. Press the ON / OFF button; you will hear the compressor catch on and the device
starts its operation.
3. Press the ON / OFF button again to switch it off again.
4. Unplug always after use.
Drainage
While the water tank is full, the compressor will stop
for self-protection and the water full indicator will turn
into red.
To move the water tank, pull it out squarely from the
unit.
After empting the water tank, place the water tank into
space. Make sure it is properly positioned, in order for
the 'water full' sign to go out and your dehumidifier is
operating.
Please note: in case, the water tank has not been
positioned well, the water full indicator will turn into
red. The equipment does not work.
Continuous drainage
When the dehumidifier is operated at very high humidity levels, the water tank will require
more frequent drainage. In this situation, it may be more convenient to set the unit up for
continuous drainage with the following procedures:
1. Pull out the water tank.
2. Remove the rubber cap from the drain pipe on the side of the tank.
10

Publicité

Table des Matières
loading

Table des Matières