emerio OFR-111385 Mode D'emploi page 7

the screen, press the "-" or "+" button to increase or decrease the temperature. The selected temperature
will flash for about 5 seconds and then stay still. Note that the temperature range is from 5 ℃ / 41 ℉
to 35 ℃ / 95 ℉.

When you have finished using the heater, press the
will send out one beep sound. The
disconnect the power. Take out the plug from the power outlet.
NOTES:
1. Long press the " ℃/℉ " button is to switch between the Celsius and Fahrenheit display of temperature,
and you will hear two beep sounds.
2. The temperature setting can only be adjusted when the temperature numerals flash on the screen.
3. If no press on the control panel for about 3 minutes, the screen will automatically shut down. Pressing any
button once can make the screen back to work. Buttons will have their functions only when the screen is
working.
Timer
Automatic turn-on: When power is connected, press the
the "+" or "-" button to set after how many hours the heater will automatically turn on.
Automatic turn-off: When the heater is on, you can press the
Use the "+" or "-" button to set after how many hours the heater will automatically turn off.
Notes:

One press of the button leads to one hour change. Time selection ranges from 1 hour to 24 hours.

After setting the timer for automatic turn-on or turn-off, there will be an icon
screen.

You can adjust the time only when the numerals flash. The time is set when numerals become still.
ECO Mode

When the heater is on, press "ECO" button to enter into the ECO mode. Press the "ECO" button again, the
heater will exit from ECO mode to the original setting.

In ECO mode, the appliance will adjust the heat output automatically according to the environmental
temperature. When the environmental temperature is higher than 28 ℃， the heater will stop heating.

In ECO mode, you cannot adjust the temperature and heat output by yourself.

A leaf-like icon will appear on the screen to indicate the ECO mode.
Child Lock Mode

When the heater is on, long press the
activated. The setting on the heater is thus locked. To exit from child lock mode, just long press the
button again and you will hear 3 beep sounds again.
button to turn off the heater, and the appliance
icon on the screen will turn to red. Press the power switch to
button to set the automatic turn-on time. Use
button to set the automatic turn-off time.
button until you hear 3 beep sounds, the child lock mode is
- 6 -
appearing on the