Before The First Use - Domo DO9198WK Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
·
Always place the appliance on a flat, stable surface
·
Always pour out boiling water slowly and carefully, making sure that you do not tip the kettle too fast.
·
Be careful when you fill the water kettle when the appliance is still hot.
·
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
PARTS
1.
Spout with removable filter
2.
Lid
3.
Button to open the lid
4.
Handle
5.
Water level indication
6.
On/off switch with indicator light
7.
Base

BEFORE THE FIRST USE

Boil a full water kettle and pour away the water. Repeat this twice before actually using the water kettle
for the first time.
USE
1.
Place the water kettle on a flat and stable surface.
2.
Remove the water kettle from its base and open the lid by pressing the top button.
3.
Fill the water kettle with the desired amount of water. Make sure that the water level is always
higher than the minimum indication (0.5 l) and lower than the maximum indication (1 l).
·
If you have not added enough water, the water kettle will switch off before the water boils.
·
If you have added too much water, the boiling water could escape through the spout. That is
why you should never exceed the maximum indication when filling the kettle. Also, always make
sure that the lid is properly closed before turning on the watter kettle.
4.
Close the lid. Make sure that it is closed well.
5.
Place the water kettle on its base.
6.
Plug in the appliance.
7.
Press the on/off switch at the bottom of the handle. The indicator will light up and the water kettle
will start the boiling process.
8.
The water kettle will automatically switch off when the water boils. You can always stop the boiling
process yourself at any moment by pushing the on/off switch upward.
·
Make sure that the on/off switch is clear of obstructions and that the lid is firmly closed. The
water kettle will not switch off automatically if the switch is hindered or if the lid is still open.
9.
Remove the kettle from the base and pour out the water.
·
Be careful when pouring the water since it is possible to burn yourself on the boiling water or the
hot steam. Do not open the lid when the water in the water kettle is hot.
10. The water kettle will not start boiling again until the switch is pressed down again. Let the appliance
cool down for 15 to 20 seconds before reopening the water kettle to boil water.
20
DO9198WK
1
2
3
4
5
6
7

Publicité

Table des Matières
loading

Table des Matières