Machine Description - LAVOR Pro MAJOR Manuel D'instructions

EN
mains.
The cleaner can only be connected to the wa-
ter mains if the water mains is separated by a
backflow preventer. Make sure that the hose
is at least Ø 13mm-1/2 inch and that it is rein-
forced.
• WARNING: Water that has flown through
backflow preventers is considered to be
nonpotable.
IMPORTANT: Only clean or filtered water
should be used for intake. The delivery of
the water intake tap should be equal to the
double of the maximum pump range.
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the machine as close to the water supply
system as possible.
Failure to comply with the above conditions
causes serious mechanical damage to the
pump and the loss of warranty cover.
Water supply from the water tank build-in
- Switch off the unit.
• WARNING: We recommend the use of demine-
ralized water.
> ELECTRICITY SUPPLY
- The appliance's electrical connection must
comply with the IEC 60364-1 standard.
IMPORTANT: Before
appliance, make sure that the nameplate
data are the same as those of the electrical
mains and that the socket is protected by a
differential security breaker with tripping
sensitivity below 0.03 A - 30 ms.
- If the appliance's plug is not compatible with
the socket, have the socket replaced with
another of suitable type by professionally
qualified staff.
- Never use the appliance in ambient
temperatures below 0° C if it is equipped
with a PVC (H VV-F) cable.
• XY WARNING: Inadequate extension cords
can be dangerous.
• XJ WARNING: If an extension cord is used,
the plug and socket must be of watertight
construction.
connecting the
18
Information for supply may also be obtained
from the plug manufacturer.
230-240V
3G 2,5 mm2
max 20 m
USAGE
> UNPACKING
Remove the upper and the lower hooks retaining
the cardboard box to the pallet, take the cardboard
box off, place two wheels of the machine on ground
and withdraw the pallet.
> Machine handling and transport
- Always use the handle supplied to move the ma-
chine.
• WARNINGS Never move the machine by using
the power cable or steam hose.
> MACHINE DESCRIPTION
see fig.AB
① Detergent tank
② Handle
③ Steam gun connection plug
④ Electric cable
⑤ Water inlet
⑥ Diesel tank
⑦ Water tank
⑲ Switch detergent device
see fig. C
Model: Major
③ Steam gun connection plug
⑳Steam outlet valve, closed
400-415V
4G 2,5 mm2
max 30 m