Remove / Delete Single Access Card - Conrad 61 17 61 Mode D'emploi

b) Remove / Delete Single Access Card
• Briefly hold the programming card "
emitted and the green LED flashes quickly. Remove the card from the sensor area.
The outdoor unit is now in deletion mode.
Now an access card (or several in sequence) can be deleted / removed.
• Briefly hold an access card in front of the sensor area (13). Two signal sounds are given out
and the card is removed / deleted.
If desired, you can hold another access card in front of the sensor area (13) until you hear
the signal again, etc.
• When all access cards were removed / deleted, hold the programming card "
sensor area briefly. This ends the deletion mode.
The red LED light is lit permanently.
–
" in front of the sensor area (13). A sound signal is
2
–
1
–
–
" before the
37