Code Card Functions; Add / Programme Access Card - Conrad 61 17 61 Mode D'emploi

10. Code Card Functions

The delivery scope includes 7 code cards:
• 1x programming card "
• 1x programming card "
• 5x access cards (for triggering the door opener)
a) Add / Programme Access Card
• Briefly hold the programming card "
emitted and the red LED flashes quickly. Remove the card from the sensor area.
The outdoor unit is now in programming mode.
Now an access card (or several in sequence) can be added / programmed.
• Briefly hold a single access card in front of the sensor area (13). Two signal sounds are given
out and the card is saved. Remove the access card from the sensor area.
Additional access cards can be added / programmed the same way. Briefly hold them in front
of the sensor area (13) one after the other.

If an access card is already stored in the outdoor unit, a warning signal sounds.
• When all access cards were added, hold the programming card "
briefly. This ends the programming mode.
The red LED light is lit permanently.
+
36
+
" for adding / programming an access card
–
" for removing / deleting one or all access cards
+
5
4
" in front of the sensor area (13). A sound signal is
2
3
+
" before the sensor area
1
+