Makita WUT02 Manuel D'instruction page 5

NOTE: Due to the detecting method of vacuum clean-
er's auto start/stop function, some vacuum cleaner
may automatically run for a few seconds when;
— Plugging the adaptor's cord when the stand-by
switch on the vacuum cleaner is set to "AUTO"
or equivalent or;
— Changing the stand-by switch on the vacuum
cleaner to "AUTO" or equivalent with the adap-
tor's plug connected to the outlet of the vacuum
cleaner.
This is not a malfunction.
To prevent the adaptor from falling off, always secure
it with the band or hook, or place it on a stable surface.
Use the band or hook for securing the adaptor onto the
vacuum cleaner. To use the hook, loosen the clamping
screw and extend the hook and then tighten the clamp-
ing screw.
When not using the adaptor, disconnect the adaptor's
cord from the vacuum cleaner.
1
2
► 1. Band 2. Hook 3. Clamping screw
To register a tool to the adaptor (wireless unit), follow
the instructions in the instruction manual of the tool to
be used with this adaptor. Refer to the section about
"tool registration".
The suitable communication channel varies depending
on the vacuum cleaner to be used with the adaptor.
Perform the channel setting when;
—
—
1.
"AUTO".
► 1. Stand-by switch
3
5 ENGLISH
Tool registration for the adaptor
NOTE: In the tool's instruction manual, follow the
instructions by substituting the wireless activation
button/lamp "on the vacuum cleaner" with "on the
adaptor".
NOTE: Make sure that the wireless unit is installed
to the adaptor and the adaptor is plugged into the
outlet of the vacuum cleaner before starting tool
registration.
NOTE: The tool registration information is saved to
the wireless unit inserted to the adaptor. You can use
a pair of wireless units, of which the tool registration
has been finished, with another tool and vacuum
cleaner.
Channel setting
Using the adaptor for the first time or;
Using another vacuum cleaner which have not
been used with the adaptor.
NOTE: The last channel that you set will be saved
even after you unplug the adaptor.
Set the stand-by switch on the vacuum cleaner to
1
NOTE: On some cleaners, the stand-by switch
"AUTO" is described as an icon or different word. In
this case, set the vacuum cleaner to auto start/stop
function.