Rear Panel - RCF AM2080 Manuel De L'utilisateur

REAR PANEL

] [
9
Channel 1 balanced audio input (removable connector):
IMPORTANT: it is necessary to either link the CMD pin to ground of the respective removable connector or use
the VOX function to open the audio input 1 (even when using the XLR plug for the audio signal).
P
Channel 2 balanced audio input (removable connector).
See 9 (channel 1 balanced audio input) for its connection.
IMPORTANT: it is necessary to either link the CMD pin to ground of the respective removable connector or use
the RJ 45 port priority command to open the audio input 2.
{
MIC-LINE input setting (channels 1 and 2) through 4 dip-switches:
OFF – PHANTOM
1
(IN 2)
-20 dBu – MIC
2
(IN 2)
OFF – PHANTOM
3
(IN 1)
-20 dBu – MIC
4
(IN 1)
20
p
i u
1
+ Hot audio input
2
- Cold audio input
3
GND ground
command: input on / priority access when connected to
4
CMD
ground
OFF: channel 2 input phantom
power is off.
-20 dBu: channel 2 input sensitivity
set to LINE (-20 dBu).
OFF: channel 1 input phantom
power is off.
-20 dBu: channel 1 input sensitivity
set to LINE (-20 dBu).
t e o
y r w
PHANTOM 2:
channel 2 input phantom power is on.
MIC 2:
channel 2 input sensitivity set to MIC.
PHANTOM 1:
channel 1 input phantom power is on.
MIC 1:
channel 1 input sensitivity set to MIC.
P { O
q }