Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – LumenSafe Ethernet Set Up Instructions
Using Stratocast Video Management System
1.
Default Axis Camera IP address is 192.168.0.90
2.
Ensure Ethernet cable being brought into fixture is connected to an Internet Enabled Router.
a.
Router should assign automatic IP address to camera.
3.
Open Lumensafe Fixture and locate "Data in" Port on PoE injector inside fixture. (Figure 1.)
4.
Connect incoming Ethernet cable to "Data in" Port* of PoE injector inside fixture.
*Note: This port will be the only open and available port on the PoE injector.
Figure 1. "Data in" Port Location on PoE Injector
5.
Pull up the camera video stream on Stratocast using the camera's Serial Number and OAK.
Using Axis or other video Management Systems
1.
Default Axis Camera IP address is 192.168.0.90
2.
Open Lumensafe Fixture and locate "Data in" Port* on PoE injector inside fixture. (Figure 1.)
3.
Connect incoming Ethernet cable to "Data in" Port of PoE injector inside fixture.
4.
Pull up camera video stream by entering the camera's IP address below into the video management system.
a.
https://192.168.0.90/
Connecting to a Local Host
1.
Default Axis Camera IP address is 192.168.0.90
2.
Ensure Host (Computer) IP is set to same subnet as the Camera. E.g. 192.168.0.XXX as follows:
a.
Change your Computer's IP address to 192.168.0.100 by going to "Control Panel" -> "Network and Internet"
->Network and Sharing Center > Local Area Connections > Properties > Internet Protocol Version (TCP/IPv4)
Properties and then configuring adapter's IP address as follows:
2
COOPER LIGHTING SOLUTIONS
IB512006EN
Installation instructions
Publicité
