Acksys WLn-xROAD Guide D'installation Rapide page 18

Mechanical characteristics
Dimensions (w/o antennas)
Weight (±1%)
Enclosure
Operating temperatures ranges
Storage temperatures ranges
Environmental specifications
Status indicators
Reset button
Software
Device configuration
Firmware upgrade
Operating modes
AP mode only
Network topology
Security
Client/Bridge mode only
Network topology
Security
Mesh mode only
Network topology
Security
More information in the reference manual for the "WLn" line of products
Power supply Input
External source
Cable
Ethernet interface
Type
Connectors
Cable
L x l x h = 185 x 64 x 35 mm
L x l x h = 7.28 x 2.52 x 1.38 in
560 g (19.8 oz)
IP66, cast aluminum housing
-25°C to +70°C (-13°F to 158°F)
-40°C to +85°C (-40°F to 185°F)
EN 61373 : 2000, Cat. 1B Mechanical
(Vibration / Shock / Bump)
EN 60068-2 (-1, -2, -11, -30) Climatical
(Cold, Dry heat, Salt mist)
10 LEDs: see LEDs definition section
Short push, anytime:
 Reset
Long push (> 2 sec.):
- while operating:
 Restore factory settings
- while in emergency upgrade mode:
 Restore factory settings
- at startup:
 enter emergency upgrade
Automatic device discovery
Built in web based utility for easy
configuration from any web browser
(username/password protection & https)
Yes (via web browser or "Acksys NDM")
AP (Access Point), Repeater,
Bridge/Client, Mesh, WDS
Infrastructure, ad-hoc or mesh
WEP, WPA-PSK/WPA2-PSK, WPA/
WPA2 with 802.1x authenticator, SSID
visibility status.
infrastructure mode
WEP, WPA-PSK, WPA2-PSK. 802.1x
supplicant. AES/TKIP/WEP encryption.
802.11s
N/A
Wide range DC input power supplies,
from 9V to 36V, with polarity protection.
6.5W average, 12W peak max.
2 meters of 2-wires cable, w/o connector
Auto MDI/MDI-X 10 Base T/100 Base Tx/
1000 Base T with automatic negotiation
(HDX/FDX), according to 802.3u.
RJ45 male
Integrated 2 meters Ethernet cat.5e cable
with RJ45, T568B standard cabling
-8-
,
ad-hoc mode