Acksys WLn-xROAD Guide D'installation Rapide page 16

RJ45 Ethernet connector
The Ethernet port is auto-sensing and self-configuring (auto-MDI/MDIX) to
allow connection to either a crossover or straight-through connector. If it
proves necessary to change the Ethernet cable, the following table indicates
the pinout of connector J4 located on the PCB.
Pin Signal name
8 DA+
7 DA-
6 DB+
5 DB-
4 DC+
3 DC-
2 DD+
1 DD-
Power supply connector 9 V – 36 V
Pin Signal name
2 + V
1 - (GND)
Antenna connectors
3 x RP-SMA female connectors
10 status LEDs indicate:
Group LED
State
Act
WLAN
Signal
Strength
Link/
Activity
ETHER
NET
10/100/
1000
Diag
ADMIN
Power
CONNECTORS
Color
White Orange
Orange
White Green
Green
Blue
White Blue
White Brown
Brown
Color
Red
Black
LEDs definition
Color
Off:
Blinking: the product is unassociated
Green
solid "On": the product is associated
Flashing : Radio Tx/Rx activity.
Blue
In client mode:
Green
In AP mode: Always off
On:
Green
Flashing: Tx/Rx activity
Yellow:
Green/
Green:
Yellow
Off:
Indication of the unit operational state :
OFF:
Red:
Red/
Red for more than 2 minutes:
Green
Green:
Blinking: Firmware in flash is not valid;
On:
Green
-6-
(J3)
The product handles power supply
wires inversion.
Description
the radio is disabled
once connected, represents
the power of the radio signal
received from the AP
Link on LAN established
connected in 1000 BASE T
connected in 100 BASE Tx
connected in 10 BASE T
Power supply is off
Initialization during 40s after
powering up, then goes Green
Hardware failure.
Ready to use
please load new firmware with
NDM
Power supply is applied.
RJ45 connector
T568B