Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.5
Placing the batteries in the remote control
1 Improper installation of batteries can result in leaks and corrosion to the battery and damage to the device.
Corrosion, oxidation, battery leaks and other gradual defects will invalidate the warranty.
4
Remove the battery cover.
5
Insert the AAA batteries matching the (+) and (-) polarity markings.
6
Re-install the battery cover.
5.6
Charging a mobile device
Use a USB cable to charge a mobile device via the USB 5 V output (15) on the projector.
6. OPERATION
Switch the projector on with the ON/OFF button (5)(28).
6.1
The main menu
The main menu has four folders: Movie, Music, Photo and Text. The current input source is indicated at the top left. The
folders can be navigated as follows:
•
To select a folder, use the arrow buttons on the remote control or the LEFT (10) and RIGHT (7) arrow buttons on the
projector.
•
To open the folder, press the OK button (26) on the remote control or the UP arrow button (6) on the projector.
•
Or, to go back a step, press the BACK button (23) on the remote control or the DOWN arrow button (9) on the
projector.
6.2
Selecting an input source
•
Go to the main menu.
•
Press the INPUT button (35) on the remote control or the INPUT/OK/PLAY/PAUSE button (11) on the projector.
•
Select the desired input source (AV, VGA, HDMI, USB, SD) with the UP (6) (32) and DOWN (9)(34) arrow buttons.
•
Confirm with the OK button (26) on the remote control or the RIGHT arrow button (7) on the projector.
5 NO SIGNAL will appear at the top left if no input source could be found. Check the input source and cables.
6.3
Opening or playing a multimedia file
•
Insert a USB storage device or Micro SD card containing the multimedia file into the appropriate input (17)(16).
•
Go to the main menu.
•
Check at the top left of the screen to verify that the correct input source has been selected. If not, select the correct
input source (USB or SD).
•
Choose from Movie, Music, Photo or Text.
•
Select the folder containing the multimedia file and press the OK button (26) on the remote control or the UP arrow
button (6) on the projector.
•
Select the multimedia file. A preview and properties of the selected file will appear after a few seconds.
•
To play the file, press the PLAY/PAUSE button (29) on the remote control or the INPUT/OK/PLAY/PAUSE button (11)
on the projector.
•
If you have played this file previously, you will be asked "Memory Play: Yes/No?". To continue playback from where
you paused it, select Yes and press the OK button (26) on the remote control or the UP arrow button (6) on the
projector. To start playback from the beginning, select No and press the OK button (26) on the remote control or the
UP arrow button (6) on the projector.
6.4
During playback
•
To mute the sound, press the MUTE button (30) on the remote control. Press the button again to unmute the sound.
•
To lower the volume, press the VOLUME DOWN button (22) on the remote control or the LEFT button (25) (10) on
the projector.
•
To increase the volume, press the VOLUME UP button (36) on the remote control or the RIGHT button (33) (7) on the
projector.
04
Publicité
Table des Matières
