BH Tecnovita YR10 FACIAL TENS Mode D'emploi Et Garantie page 13

5. Press POWER to start the Mirage Wrinkless system. (if the
LCD flashes with audible alarm, check connection of the facial
pads).
6. Press UP/DOWN to adjust desired intensity. (fig4) (NOTE:
intensity is set to 0, when stimulation initiates.)
Fig.1
7. If you wish to interrupt the operation, press button (1).
8. To continue with the operation press button (1) again.
9. To return to setting menu press button (2). SELECT.
10. After the run time selected, the device will be notified through
a soft beep. Press any key to stop the beeping. To turn off hold
down (1) for several seconds.
Fig.2
Fig.3
24
English
Fig.4
Fig.4
Fig.5
Notes:
● If the pads are not properly attached, it will stop functioning
and will produce a soft beep.
• The selected parameters will appear as a predefined program in
the following use.
Recommendation
For best results and to prolong the life of the device as
possible:
• Don't use the device more than 3 times in a day and not
more than 3 consecutive days.
• Place the pads on clean skin.
• Protect the pads with plastic wrap and store it with a
plastic bag that comes with the package.
• Make sure the pads are well bonded.
• Repeat facial clean process and apply serum, lotion or facial
skin care products after application.
25