General Safety Information - AAA 10.0 GA13 Manuel D'utilisation

INSTRUCTION MANUAL
INDUSTRIAL TRIPLEX PUMPS

GENERAL SAFETY INFORMATION

Please read and save these instructions.
Read carefully before attempting to
assemble, install, operate or maintain
the product described. Protect yourself
and others by observing all safety
information.
instructions could result in personal
injury and/or property damage! Retain
instructions for future reference.
DANGER: RISK OF
INJURY FROM SPRAY
Always wear safety glasses or goggles
and appropriate clothing.
WARNING: RISK
OF BURSTING
WARNING: RISK OF
HOT SURFACES
WARNING: This product and its
exhaust contain chemicals known to the
State of California to cause cancer, birth
defects or other reproductive harm. In
addition, some cleaning products and
dust contain chemicals known to the
140*213MM
Failure to comply with
2- ENG
Industrial Triplex Pumps
State of California to cause cancer, birth
defects or other reproductive harm.
Wash hands after handling.
WARNING: Adequate protective
guards must cover all moving parts.
Perform routine maintenance on the
pump and components.
WARNING: Use only components
that are rated for the flow and pressure
of the pump, this would include hose,
fittings, safety valves, spray guns etc.
DESCRIPTION
Designed to work at 3400 RPM when
coupled to a gasoline engine. The 1"
(25.4 mm) hollow shaft and universal
mounting flange provides connection
to most 1" (25.4 mm) shaft, horizontal
engines.
SPECIFICATIONS
Oil Capacity: 13 oz. (384 ml)
Ports
Inlet Port (Supplied): Standard
garden hose connection with inlet
strainer.
Discharge Port (Supplied): 3/8"
Quick Connect connection.
Thermal Relief Valve
When the temperature inside the pump
rises too high, this valve will open and
release a gush of water in an effort to
lower the temperature inside the pump.
The valve will then close.
Detergent Injection System (Supplied):
Mixes cleaners or cleaning solvents
with the water to improve cleaning
effectiveness.
NOTICE: Allowing the unit to run for
more than two minutes without the
gun trigger being pulled could cause
overheating and damage to the pump.
(Supplied):