BPS 25/40V PLUS
PROBLEM
Motor stops while
cutting
Motor does not run or
runs intermittently
Motor runs, but saw
chain does not rotate
Pole saw does not cut
properly
Bar and chain excessive-
ly hot and/or smoking
Low cut time per bat-
tery charge
TROUBLESHOOTING
POSSIBLE CAUSE
Chain pinched in cut
Overheating of control system
Battery discharged
Safety switch not pressed
Battery pack not fully inserted
Battery contacts dirty
Battery pack cold
Debris in side cover
Overheating of motor
Chain not engaging drive sprocket
Guide bar nose sprocket is not
turning
Insufficient chain tension
Dull chain
Chain installed backwards
Worn chain
Dry or excessively stretched chain
Chain not in bar groove
Chain is under-lubricated
Dull chain
Worn chain
Dry chain
Over tensioned chain
Improper cutting technique
Debris in side cover
Battery pack not fully charged
ENGLISH
RECOMMENDED ACTIONS
Undercut limb to relieve pressure on limb.
Let the control system cool down.
Charge the battery
Press the safety switch before squeezing the trigger
switch
Press the battery pack into the battery port until it clicks
into place
Remove the battery pack, remove debris from the battery
port, and then clean the contacts with a clean, dry cloth
Allow the battery pack to warm to the minimum operating
temperature of 0°C
Remove battery pack, then remove chain sprocket cover
and clean out debris
Let the motor cool
Reinstall the chain, making sure the drive links on the chain
are fully seated on the drive sprocket.
Replace the guide bar
Tension the chain
See MAINTENANCE
Install the chain with the teeth facing the correct direction.
Replace the chain
Check the oil level. Refill oil reservoir if necessary
Reseat chain onto groove
Check the oil level. Refill oil reservoir if necessary
Replace the chain
Check the oil level. Refill oil reservoir if necessary
See TENSIONING THE CHAIN
Follow guidelines in SAWING TECHNIQUES
Remove battery pack, then remove side cover and clean out
debris
Recharge the battery
English |
53
www.ffgroup-tools.com