Battery Installation - Bresser NightSpy 3x42 Mode D'emploi

• Avoid dropping or otherwise shocking the unit. Although designed for
rugged outdoor use, the NightSpy 3x42 incorporates a sophisticated
optical system which could be damaged in extreme cases of misuse.
• Clean optical parts (lenses) with professional lens cleaning supplies
designed for use with multicoated optics.
• Clean the exterior of your NightSpy 3x42 with a soft, clean cloth.
Damage to this device from failure to observe these warnings may
void the NightSpy's warranty!

BATTERY INSTALLATION

To install, unscrew the battery compartment cover (6), insert the battery
(CR123A) into the battery compartment so that the positive (+) and negati-
ve (-) terminals of the battery match the markings inside the compartment,
replace the battery cover carefully. Do not over tighten.
USING THE NIGHT SPY
After installing the battery the NightSpy is ready for use. Please keep the
following points in mind:
• Move into a dark area before activating the NightSpy 3x42 light ampli-
fier.
• Remove the lens cap (5) and store in pocket provided.
• Activate the device by pushing the „ON" button (1).
• If the subject to be viewed is in a complete dark area, including lowlight
shadow areas, activate the infrared illuminator by pressing the "IR"
Button (2).
• Direct your NightSpy 3x42 device at an object at a distance approxi-
mately 100 yds. Adjust the eyepiece (4) and objective lens (3) diopter
setting to focus the unit by rotating the eyepiece (4) and objective lens
(3). After the adjustment, do not rotate the eyepiece irrespective of the
distance and other conditions.
• Direct your NightSpy 3x42 device at the subject to be viewed and adjust
the final focus by rotating the objective lens (3) focusing ring until the
image quality is optimal.
• The green LED (8) indicates that the light amplifier unit is on. The
red LED (9) indicates that the IR illuminator is on. Do not store your
NightSpy 3x42 when any of the indicators are lit. When you finish using
your NightSpy 3x42, turn off the entire unit including the IR illuminator
and light amplifier. Return the lens cap (5) to the objective lens.