LENCO DAR-012 Mode D'emploi page 6

1. Volume Knob
2. Power Button
3. Function Button
4. Preset Button
5. Dimmer Button
6. Menu/Alarm Button
7. Select/Time Button
8. Info Button
9. Scan/Pair Button
10. LENS
11. LCD Display
12. Tuning/Enter knob
13. AUX IN left
14. AUX IN right
15. Battery Compartment
16. Clock Back up Battery (Batteries not included)
17. FM Telescopic antenna
18. AC Power Cord
Instructions
Basic operations
Mains Connection
Make sure that all of the components are connected correctly.
Check that the voltage level required by your equipment matches the local mains supply,
namely AC 230V ~50Hz. Plug the AC plug into the wall outlet.
Clock back up battery
- Open the battery compartment cover
- Insert 2xAAA size 1.5V batteries, ensuring correct polarity as indicated inside the battery
compartment.
NOTE: Check your batteries regularly, old or discharged batteries may leak and damage the
unit. When replacing batteries always ensure you do not mix old and new batteries and
replace with the same type batteries.
Power Management:
When there is no signal of AUX/BT for 10 minutes, unit will go to standby.
6