Front Panel; Rear Panel - BST Pro UPP-1480 Manuel D'utilisation

DESCRIPTION

FRONT PANEL

1. INDICATORS
SIGNAL LED
The illumination of these led only indicates a safe operation. More the level of the signal is high, more the leds flashes
CLIP LED
These leds light on if the signal is too high. The sound can be distorted. Decrease level in using channel level controls.
PROT LED
When these indicators light, that means the power amplifier is in the protection mode. Switch off the device and find out the
problem.this power amplifier is protected against over heat, over load, short circuit, dc, softstart.
POWER LED
This led light's on when you switch the power amplifier on.
2. POWER SWITCH
Use this switch to switch your power amplifier on
3. AIR EXIT
Please don't obstruct this part

REAR PANEL

4. GROUND CONNECTOR
5. AC SOCKET + FUSE
Plug the ac power cord into any standard ac outlet. Before plugging this cord in, be sure the voltage of ac outlet is correct.the fuse is used to
protect your power amplifier from different kinds of ac problems. If the power amplifier is "on" and nothing lights, please verify the fuse
compartment. If fuse is broken, please read it and change with a new one of same size and value.
6. DC CONNECTORS
Connect on these sockets a DC power source ( as rechargeable batteries,... )
7. LINK OUPUT
Connect on this output an other power amplifer, a record device or an active speaker. Connector : XLR, Jack, Cinch and terminal blocks
8. INPUTS
Connect on this input your sound device ( cd player, tuner, mixer or passiv output of a power amplifier mixer )
Connector : XLR, Jack, Cinch or Terminal blocks
9. INPUT LEVEL CONTROL
Use this control to adjust the level. Note : If the signal level is too high, the sound must be saturated and the power amplifier must be enter
in protection mode.
© Copyright LOTRONIC 2014
UPP-1480
UPP-1480
Page 6