Notes • Guidelines • Guarantee; General Safety Notes; Guarantee; Details - asecos GAP Série Notice D'utilisation

1. NOTES • GUIDELINES • GUARANTEE
2. ERECTION • COMMISSIONING • FUNCTION
WITH BASEFRAME
OPTIONAL
1010

1.1. GENERAL SAFETY NOTES

• Take notice of the legislation and provisions to be applied in dealing with hazardous materials.
• Only use the hazardous material workplace in a proper condition.
• Make sure that there are no air currents above 0.2 m/s when selecting the place of erection as
this can a ect the functional capability.
• The users are to be trained on handling of the hazardous material workplace.
• Observe the maximum weight with which the cabin may be loaded.
• Please check the material resistance of all surfaces for the use of aggressive materials.
• Any hazardous materials that escape must immediately be collected and removed.
• Take note of all information in these operating instructions.
• Please follow the instructions of the safety specialists, technical monitoring services, construction
supervision etc.
• Please observe accident prevention and workplace regulations.
• The required exhaust air fl ow is to be provided on site.

1.2. GUARANTEE

The guarantee for this product is agreed between you (the customer) and your dealer (the
seller). Independently of this, the manufacturer provides a guarantee for the products listed in
the operating instructions for 24 months after the date of sale. All model safety equipment are
subject to a compulsory annual inspection by specialised sta authorised by the manufacturer. If
this inspection is not carried out annually, or not carried out by specialised sta authorised by the
manufacturer, the customer's guarantee claims against the manufacturer will be invalidated.

1.3. DETAILS

Development: asecos GmbH Sicherheit und Umweltschutz, D-63584 Gründau.
Serial No.
Technical drawings
CE declaration of conformity
Hazardous material workplace GAP
Complete capture of hazardous vapours, gases or suspended solids at the place where they emerge
or where they are created before they can have e ects that are damaging to health or to the envi-
ronment (see hazardous materialsregulations, workplace regulations and laboratory guidelines).

2.1. ALIGNMENT OF THE WORKPLACE

See type plate on the front of the hazardous material workplace
Appendix 1
Appendix 2
2
3