Haussmann Xpert PT102602 Guide De L'utilisateur page 22

!
(1. Switch trigger)
(1. Reversing switch lever)
ASSEMBLY
Fitting and removing the battery pack
1. Button
2. Battery pack
WARNING : Do not continue to press the On/Off switch after the
tool has been automatically switched off.
The battery can be damaged.
The battery is supplied partially charged. Completely charge the battery before
using your power tool for the first time. The battery can be charged at any time
without reducing its service life. Interrupting the charging procedure does not
damage the battery.
a) Always switch off the tool before insertion or removal of the battery pack.
b) To insert the battery pack (2), align the tongue on the battery pack with the
groove in the housing and slip it into place. Always insert it all the way until it
locks in place with a little click. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
c) To remove the battery pack (2), by pressing the battery unlocking button 1 on
both sides and pulling the battery out of the power tool toward the rear.
d) Do not use force when inserting the battery pack. If the pack does not slide in
easily, it is not being inserted correctly.
Starting and stopping
1. Starting: To start the tool, simply squeeze the switch trigger.
2. Stopping: Release the switch trigger to stop.
Note: Tool speed is increased by adding pressure on the switch trigger.
Run-on Brake
When the Switch trigger (4) is released, the chuck brakes to a stop, thus
preventing the run-on of the tool.
When driving in screw, wait until the screw is screwed in flush with the material
and then release the Switch trigger (4). By doing so, the head of the screw does
not penetrate into the material.
Reversing switch action
1) This tool has a reversing switch to change the direction of rotation. Depress
the reversing switch lever from the A side for clockwise rotation or from the B
side for counter-clockwise rotation.
2) When the reversing switch lever is in the neutral position, the switch trigger
cannot be pulled.
21