Troubleshooting - Franklin Chef FWC36 Mode D'emploi

Wine Cellar Troubleshooting
Wine cellar does not turn on
Not plugged in.
Fuse blown or circuit breaker tripped
Noise or vibration
Check that unit is level. If not, use leveling leg.
Wine cellar is too warm
Check that door is properly sealed.
To change the temperature, follow the steps in the the Operating Your Wine Cellar section of
this manual.
LCD displays "PROBE ERROR – E"
This message is an ALARM MODE indication. The LCD displays "PROBE ERROR" on the
left and "E" in the middle when the thermostatic sensor has malfunctioned. When this hap-
pens, the cellar first stops working for 25 minutes, then turns ON for 30 minutes and OFF for
20 minutes automatically and continuously. Contact your authorized service facility for sen-
sor replacement.
LCD displays "LOW TEMP"
This message is an ALARM MODE indication. The LCD displays "LOW TEMP" on the left
and the actual temperature reading in the middle. It indicates that the actual temperature is
much lower than your set temperature and that the magnet valve may not be functioning
properly and should be replaced. Contact your authorized service facility immediately.
LCD displays "HIGH TEMP"
This message is an ALARM MODE indication. The LCD displays "HIGH TEMP" on the left
and the actual temperature reading in the middle. It indicates that the actual temperature is
much higher than your set temperature. Possible causes are:
• The door might not be fully closed.
• The refrigerant may have leaked.
• The magnet valve may not be functioning properly and should be replaced.
If you are certain that the door is not the cause of the problem, contact your authorized serv-
ice facility immediately.
7