Care And Cleaning; Troubleshooting - Franklin Chef FCW100 Mode D'emploi

Care and Cleaning of Your Wine Cellar
Cleaning the Outside
Clean the outside of your unit with mild soapy water. Dry thoroughly with a soft cloth. To
clean the door gasket, use only mild soapy water. Never use harsh detergents or scouring
pads to clean any part of your Wine Cellar.
Cleaning the Inside
Unplug your Wine Cellar and remove all bottles. Rinse the inside surface with plain water and
dry the chrome shelves.
Wine Cellar Troubleshooting
Wine cellar does not turn on
Not plugged in.
Fuse blown or circuit breaker tripped
Noise or vibration
Check that unit is level. If not, use leveling leg.
Wine cellar is too warm
Check that door is properly sealed.
To change the temperature, follow the steps in the the Operating Your Wine Cellar section of
this manual.
LCD displays "E" (Error) symbol
This symbol indicates that the thermostatic sensor has malfunctioned and needs to be
replaced. Contact your authorized service facility immediately.
LCD displays "L" (Low) or "H" (High) symbols
These messages indicates that the actual temperature in the Wine Cellar is either much cold-
er or warmer than your set temperature and that the magnet valve is not functioning properly.
Contact your authorized service facility immediately.
7