Installation Of Mobile Printer - Dicota DataCourier Mode D'emploi

User Manual DataCourier

Installation of mobile printer

Installation of mobile printer
Open your DataCourier and proceed as follows:
1) Take four Velcro pads and press two corresponding pairs together. (Fig. 1 showing a pair being
pressed together)
2) Now you have two Velcro pairs with protective films on each side. Remove the protective film on
one side of each pair to reveal the adhesive tape beneath and press them to one corner each of
your printer. (Fig. 2; the white tape must still be removed, the Velcro pads can also be placed in
the center of the printer)
CAUTION!
Before you mount the printer, please check the intended position on the flap since incorrect mounting can cause
problems during printer operation.
3) The easiest way to mount the printer is on the open front flap. Mount the printer with its back
side (battery side) on the closed cable box in the center and press against the lid. The further back
you mount the printer the better for balance, since then the DataCourier does not tip over so easily.
For more information please contact us at info@dicota.com.
Fig. 2
Fig. 1
8