Parts List
To assist you in identifying components of your vacuum, the parts have
been numbered as follows:
1
Handle section, upper
2
Tube, lower
3
Power head
4
Outer bag
5
Paper filter dust bag
6
Power cord
7
Retaining spring
9000 Series Parts Only
16 Buttons
17 Rubber Collars
Straight Handle w/o Light
17
16
9
11
1
5
16
17
12
4
2
6
10
7
14
8
3
3000 & 4000
Series Power Head
3
Assembly
fig. 1 Before assembling appliance, remove two screws from connector
assembly. If cardboard insert present then, remove insert by
pulling upward.
fig. 2 Slide upper handle section over
matching section of the connector
assembly. Insert short screw into top
hole and long screw into the bottom
hole then tighten firmly until handle is
no longer loose. For units with a
handle plug, insert plug on cord
assembly into handle. Machine should
be in upright position when inserting
cord assembly into handle.
fig. 3 Attached cord to cord clip by pressing above and below clip
ensuring the cord is fully rested in clip. (Note: Some units come
with an enclosed cord clip that is already assembled.)
Operating Instructions
Make sure disposable paper filter dust bag is in place. DO NOT operate
the cleaner without a paper filter dust bag. Plug the power cord into an
electrical outlet.
Single-Speed Helping Hand
Handle: Press the On(l) - OFF(O) switch
®
on handle assembly when ready to operate.
E
N
8
Bag tension bar
9
Zip fastener
10
On/off switch
11
Cord hook
12
Plastic loop/cable clamp
13
Connector assembly
14
Fan housing
15
Cord assembly
Helping Hand
®
Handle w/Light
10
9
1
12
5
13
4
2
14
7
8
3
Handle
Plug
G
L
I
S
H
Two-Speed Helping Hand
- OFF(O) switch on handle assembly when ready to operate.
Switch On Base: Press the On (l) - OFF (O) switch on top of base
when ready to operate.
Up-Position Lock
fig. 4 Place foot on power head and lean handle back gently to release
lock for vacuum use. Return handle to the full upright position to
engage lock.
NOTE: Do not operate the unit while in the upright and locked position.
Do not let the unit run while in any one stationary position for any period
of time. Keep the unit moving while in operation.
For Easy Power Cord Storage
fig. 5 Wrap power cord around cord hook on handle and cord hook on
connector. Secure to "U" shaped part on plug.
Operating Recommendations
This ORECK XL High-Speed Upright is one of the finest, fastest, and
strongest units in its class. You'll love the way it cleans, gets under
things, and it's SO lightweight and easy to use.
11
The following are a few simple suggestions regarding its operation:
1. When inserting a new disposable paper filter dust bag—FIRST
PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or makes an
unusual noise, STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and other small
objects, it is recommended that these be removed from the floor
before you vacuum. Failure to do so may result in permanent
6
damage to the motor suction fan and its housing.
5. WARNING: Do not use your vacuum cleaner on damp or wet
surfaces. This will cause damage to the vacuum cleaner and is
15
dangerous to the user. Damage caused by use on wet or damp
surfaces is not covered under warranty.
6. REPLACE THE BELT EVERY 6 MONTHS.
7. Change the disposable filter dust bag at least once a month—even
if it is not full! The collected dust in the dust bag can cause odor,
attract moisture, and can affect the efficiency of the cleaner.
8. DO NOT run the vacuum cleaner over the cord. The revolving
brush could damage the cord.
9. Use caution when vacuuming over area rug edges and fringe.
General Information
The performance of your cleaner greatly depends upon care and mainte-
nance. The instructions in this manual will guide you in performing basic
care and maintenance. To obtain the most satisfying years of service
read the instructions and keep them handy for future reference.
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role in the
efficiency of your ORECK vacuum cleaner. The purpose of the paper
bag is to trap dirt, but at the same time it must be porous enough to
allow air to pass through. If the paper bag becomes clogged, no air can
pass through the cleaner and cleaning cannot take place, regardless of
the cleaner's power.
To keep your cleaner operating at maximum efficiency, change the dust
bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE
DUST BAG.
Be sure the disposable paper filter dust bag is installed properly.
All paper dust bags are not the same. Your ORECK disposable dust
bags have been designed to be used with the ORECK cleaner.
Using bags other than genuine ORECK TYPE CC disposable bags
will affect the cleaning ability of your cleaner and could cause
damage to it.
4
Handle: Press the On-High (ll) - On-Low (l)
®