Bluetooth Pairing - THOMSON WHP-6005BT Mode D'emploi

• Once the charging process is complete, the indicator
LED goes out.
• Disconnect all cable and mains connections after use.
5. Operation

5.1 Bluetooth pairing

Note – Pairing
• Make sure that your Bluetooth-capable terminal
device is on and Bluetooth is activated.
• Make sure that your Bluetooth-capable terminal
device is visible for other Bluetooth devices.
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should be no
further than 1 metre apart. The shorter the distance,
the better.
• Make sure that the headset is fully charged and
switched off.
• Press and hold the multifunction button (1) for about 6
seconds to turn the headset on. It automatically enters
pairing mode. The white and blue indicator lights flash
alternately. The headset is searching for a Bluetooth
connection.
• Open the Bluetooth settings on your terminal device
and wait until "6005BT" appears in the list of Blue-
tooth devices found.
• Select "6005BT" and wait until the headset is listed as
connected in the Bluetooth settings on your terminal
device.
Note – Bluetooth password
Some terminal devices require a password in order to
connect to another Bluetooth device.
• If your terminal device requests a password for
connection to the headset, enter 0000.
Note
• If pairing was successful, the display flashes quickly
in blue ten times and then flashes once every 6
seconds.
• If pairing was not successful, the display remains
permanently illuminated, and you will have to
perform pairing again.
• The display will go out if pairing takes longer than
60 seconds.
• If this happens, you will need to switch the headset
off and on again if you want to pair it with your
terminal device again.
• You can now use the headset.
5.2. Automatic Bluetooth connection (after
successful pairing)
• Make sure that the headset is switched on.
• Press the multifunction button (1) to automatically
connect the headset with your terminal device.
• You can now use the headset.
Note – Connection impaired
If the Bluetooth connection is not established
automatically, check the following:
• Check the Bluetooth settings of your terminal
device to see whether "6005BT" is connected. If
not, repeat the steps listed under 5.1. Bluetooth
pairing.
• Check whether obstacles are impairing the range. If
so, move the devices closer together.
• The performance can also be affected by a weak
battery.
3