Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Set plate (A)
Groove
Fig. 29 (Correct installation)
3/64" (1 mm)
Blade
(2) Place the blade holder on the completed assembly,
as shown in Fig. 31, and fasten it with the three bolts.
Ensure that the bolts are securely tightened.
Bolt
(3) Turn the cutter block over, and set the other side in the
same manner.
3. Adjustment of cutter blade height:
CAUTION
As the set gauge has been accurately factory
adjusted, never attempt to loosen it.
Blade
3/64" (1 mm)
Cutter block
Fig. 30
Blade holder
Fig. 31
(1) Loosen the 2 screws holding on the blade and set
plate (A). (Fig. 32)
(2) Press the turned surface of set plate (A) to the wall
surface b while adjusting the blade edge to the wall
surface a of the set gauge. Then, tighten them with the
2 screws. (Fig. 33, 34)
Machine screw
Set plate (A)
Turned surface
SHARPENING THE CUTTER BLADES
Use of the accessory Blade Sharpening Ass'y is
recommended for convenience.
(1) Use of Blade Sharpening Ass'y.
As shown in Fig. 35, two blades can be mounted on
the blade sharpening ass'y to ensure that the blade
tips are ground at equal angles. During grinding,
adjust the position of the cutter blades so that their
edges simultaneously contact the grinding stone as
shown in Fig. 36.
English
Machine screw
Fig. 32
Fig. 33
Blade
Wall surface a
Set gauge
Wall surface b
Fig. 34
17
Publicité
Table des Matières
