Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
7. Stand
Lift the back of the planer to extend the foot from the
base. Having the stand extended when you put the
planer down prevents contact between the blade and
the material.
8. Regulating the guide (Fig. 13)
The planing position can be regulated by moving the
guide to the left or right after loosening its set screw.
The guide may be mounted on either the right or left
side of the tool.
Set screw
Work Precautions
○ About Continuous Operation
This tool is provided with a protective function to
extend battery life.
The battery may become overheated during
continuous operation or deep cutting operations,
which may cause it to automatically stop.
Especially with any of the batteries listed below, the
tool may stop operation before the battery starts to get
hot to prevent rapid failure from overheating.
If this happens, stop operation, remove the battery
from the tool and leave it in a well-ventilated location
not exposed to sunlight until it is suffi ciently cool.
The battery can be used again once it is cool.
(Applicable batteries: BSL1825, BSL1820, BSL1815
and old batteries)
○ Proper Battery Usage
When the tool is used with any of the batteries listed
below, it should be used for light work to extend
battery life.
Work example: Shallow depth fi nishing and
chamfering work
(Applicable batteries: BSL1825, BSL1820, BSL1815
and old batteries)
14
Stand
Fig. 12
Guide
Fig. 13
CARBIDE BLADE ASSEMBLY AND
DISASSEMBLY AND ADJUSTMENT OF
CUTTER BLADE HEIGHT (FOR DOUBLE
EDGED BLADE TYPE)
WARNING
● To prevent accidents, ensure that the power tool
is switched off and pull out the battery.
● Be careful not to injure your hands.
1. Carbide blade disassembly
(1) As shown in Fig. 14, loosen the blade holder with the
attached box wrench.
Blade holder
(2) As shown in Fig. 15, remove the carbide blade by
sliding it with the attached box wrench.
Carbide blade
(Double edged blade type)
2. Carbide blade assembly
CAUTION
Prior to assembly, thoroughly wipe off all swarf
accumulated on the carbide blade.
(1) As shown in Fig. 16, lift set plate (B) and insert the new
carbide blade between cutter block and set plate (B).
Box wrench
Fig. 14
Fig. 15
Publicité
Table des Matières
