Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
APPLICATIONS
○ Planing various wooden planks and panels
Fig. 4-A (Planing)
Fig. 4-D (Tapering)
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 5).
Pull out
Insert
Battery
10
ASSEMBLY AND OPERATION
Fig. 4-B (Beveling)
23/64"(Max)
(9mm)
Handle
Latch
Push
Fig. 5
Fig. 4-E (Side planing of fl ush door)
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's pilot
lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
23/64"(Max)
(9mm)
Fig. 4-C (Rabbeting)
Side face cutting
Publicité
Table des Matières
