wallas 88DU Instructions D'installation, De Fonctionnement Et D'entretien page 76

Installation
Connection to a separate tank
Cap run-throughs and sinter fi lters are used on plastic tanks.
Volume length x height x width
5 l 200 x 300 x 130
10 l 380 x 195 x 210
30 l 590 x 200 x 300
130 l 800 x 400 x 600
Wallas fuel tanks
Installation instructions for Tank connection 367215 (accessory)
If the fuel will be taken from a separate tank, you must install a tank connection
367215.
There are two methods to install the tank connection to the stove.
The recommended way is to use the stove's own fuel hose.
1. Detach the sinter bronze fi lter from the tank connection hose and pull the fuel
hose from the cap.
2. Thread the stove's fuel hose through the connector in the tank cap. This is
easier, if you use, for instance, soapy water to lubricate the hose.
3. Install the fi lter at the end of the hose.
4. Install the tank connection in the tank.
This installation method does not involve opening the cooling box of the stove or
the factory connection to the fuel pump.
An alternative way to install the tank connection:
1. Open the cooling case of stove and detach the stove's standard fuel hose from
the fuel pump.
2. Thread the tank connection hose through the hole in the cooling case lid.
3. Install the tank connection hose by fi rst threading the barrel nut to the hose, after
which the support sleeve should be placed inside the hose and the olive at the end
of the hose.
4. Tighten the barrel nut tightly to the fuel pump connector. Keep the parts and the
hose clean and ensure that the connection is tight, because an air leak in the con-
nector will stop the device from functioning.
5. Install the cooling case back to the stove.
Support sleeve ø 2 mm
Olive ø 5 mm
88DU
Order code
2024
2027
4030
4130
Barrel nut
Protection spiral
Barrel nut
Seal
Washer
Sinter bronze fi lter
- 76 -
GB
(accessory)
(accessory)
(accessory)
(accessory)
Bleeding hose
Attach the loose end of the
hose so as to not allow fuel
to spill as the boat tilts.
Screw cap
Cap seal
490070GB