wallas 88DU Instructions D'installation, De Fonctionnement Et D'entretien page 74

Installation
FUEL CONNECTIONS
Things to note about the connections
The standard length of the fuel hose is 4 m (max 8 m). Cut the fuel hose to a length
suitable for installation.
The lift height of the pump should be less than 2 m; preferably 0.5 – 1 m.
The fuel pipe must always have a fi lter. The fuel fi lter can be installed either near
the device, near the tank, or in another location where it can be easily checked and
replaced, when necessary.
All connections should be made with rubber or silicone hose which is resistant to
diesel.
Country-specifi c requirements
The standard fuel hose is plastic. Please observe country-specifi c requirements
with regard to the material of the fuel hose/pipe and the fuel fi lter. The inner diam-
eter of a new replacement hose must be equal to the inner diameter of the plastic
hose.
Copper pipe and metal fi lters are available as accessories.
Fuel feed
If the lift height is outside the recommended 0.5 – 1 m, the fuel feed must be
checked and, if necessary, adjusted. The fuel feed must also always be checked,
if parts of the fuel system, such as the pump or the electronics card, have been
replaced.
Fuel system adjustments are device specifi c. We recommend that the adjustment
be carried out by an authorised service shop.
Optimal fuel tank
location
The fuel connections must be tightened fi rmly so as to not allow air to
leak into the hose. Always check the cleanliness of the connection sur-
faces before tightening.
Air will cause the device to malfunction.
88DU
Checking /
adjustment
0,5 m
OPTIMUM
1 m
Checking /
adjustment
MAXIMUM 2 m
- 74 -
GB
TANK
TANK
TANK
490070GB