Table des Matières
Publicité
Anleitung_RWW_830_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
Caution!
In stagnant water bodies, garden ponds,
swimming ponds and their surrounding areas
the unit may only be used with an earth-leakage
circuit breaker with an actuating rated current of
up to 30 mA (according to VDE 0100 Part 702
and 738).
The equipment is not designed for use in
swimming pools and paddling pools of any kind
or other bodies of water in which people or
animals may be present during operation. It is
prohibited to operate the equipment if a person
or animal is in the danger area. Ask your
electrician!
This equipment is not designed to be used by people
(including children) with limited physical, sensory or
mental capacities or those with no experience and/or
knowledge unless they are supervised by a person
who is responsible for their safety or they have
received instructions from such a person in how to
use the equipment safely. Children must always be
supervised in order to ensure that they do not play
with the equipment.
Important!
Always inspect the equipment visually before
using it. Do not use the equipment if safety
devices are damaged or worn. Never disable
safety devices.
Use the equipment only for the purposes
indicated in these operating instructions.
You are responsible for safety in the work area.
If the cable or plug is damaged by external
influences, the cable may not be repaired. The
cable must be replaced by a new one. This work
may only be carried out by a trained electrician.
The voltage of 230 V alternating voltage
specified on the rating plate must be the same as
18.07.2011
8:42 Uhr
Seite 9
the mains voltage.
Never use the power cable to lift, transport or
secure the equipment.
Ensure that the electrical plug connections are in
areas that are not at risk of flooding or protect
them from moisture.
Pull the mains plug before starting any work on
the equipment.
Do not expose the equipment to a direct jet of
water.
The operator is responsible for complying with
local safety and installation regulations. (Ask an
electrician if you are in any doubt.)
Consequential damage caused by flooded rooms
in the event of the equipment suffering faults
must be prevented by the user by means of
suitable measures (for example installing alarm
systems or a reserve pump, etc.).
In the event of a failure, repair work may only be
carried out by an electrician or by ISC after sales
service personnel.
The equipment must never run dry or be used
when the intake line is closed fully. The
manufacturerʼs warranty does not cover damage
caused to the equipment as a result of running it
dry.
The pump must not be used to operate
swimming pools.
The equipment must not be installed in the
drinking water pipe line.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Pressure connector
2. Water drain screw
3. Pressure gauge
4. Suction connector
5. Water filler screw
6. Pressure switch
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
GB
9
Publicité
Table des Matières
