Troubleshooting - Danby DBC434A1SDB Guide D'utilisation Et Soins De Propriètaire

Troubleshooting

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this trou-
bleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or
Danby's Toll Free Number 1-800-263-2629 for assistance.
Problem
No Power.
Cabinet Temperature
too High
)
"Clicking" Noise
Condensation on the
cabinet and/or doors
Possible Cause What to do
A fuse in your home may
be blown or the circuit
breaker tripped.
Power surge.
Plug not fully inserted into
wall outlet
Temperature setting
Door(s) not shut properly
or opened excessively
Recently added a large
quantity of warm bottles
to the cabinet
Normal sound
High humidity conditions
in the home
Door(s) not shut properly
or opened excessively
9
Replace fuse or reset circuit breaker.
Unplug the beverage centre, wait a
few seconds and then plug it back in.
Make sure the 3-prong plug on the
beverage centre is fully inserted into
outlet.
Verify the temperature control setting.
Adjust if neccessary.
Ensure that the doors are fully closed
and that the gaskets are sealing
against the cabinets. Open the doors
only as needed and for short periods
of time.
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to phase in the
load introduction if possible.
No user intervention is required as
this sound is normal during the opera-
tion of the appliance. This audible
'clicking' noise may be heard as the
appliance ends or begins a cooling
cycle.
The condensation will subside once
humidity conditions return to normal.
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinet. Open the door only as
needed and for short periods of time.