Troubleshooting - Danby DBC039A1BDB Guide D'utilisation Et D'entretien

Troubleshooting

Occasionally, a problem is minor and a service call may not be necessary. Use this troubleshooting
guide for a possible solution. If the unit continues to operate improperly, call an authorized service
depot or our Toll Free Number 1-800-263-2629 for assistance.
PROBLEM
No power
Cabinet temperature
is too high
Clicking noise
Condensation on
the cabinet and/or
doors
POSSIBLE CAUSE
• A fuse in your home may be
blown or the circuit breaker
tripped
• Power surge
• Plug not fully inserted into wall
outlet
• Temperature is set too high
• Door is not shut properly or
opened excessively
• Exhaust vent is obstructed
• Recently added a large quan-
tity of warm beverages to the
cabinet
• Normal sound
• High humidity conditions in the
home
• Door not shut properly or
opened excessively
• Replace fuse or reset circuit
breaker
• Unplug the wine cooler, wait a few
seconds and then plug it back in
• Make sure the 3-prong plug is
fully inserted into the outlet
• Verify the temperature control
setting, adjust if neccessary
• Ensure that the door is fully
closed and that the gasket is
sealing against the cabinet. Open
the doors only as needed and for
short periods of time
• Verify there is nothing blocking
the front mounted exhausting vent
• Limit the quantity of warm bev-
erages being introduced to the
cabinet at the same time. Attempt
to stagger the load introduction if
possible
• This is normal. A clicking sound
may be heard as the appliance
ends or begins a cooling cycle
• The condensation will subside
once humidity conditions return to
normal
• Ensure that the door is fully
closed and that the gasket is seal-
ing against the cabinet. Open the
door only as needed and for short
periods of time
9
SOLUTIONS