EHEIM VAC40 Mode D'emploi page 16

English
4. Commissioning
Assembly type 5360 (⌦C)
1. Connect the metal bracket a to the container base.
2. Tighten with both screws from below (Â size 5).
Switch illustration c
= AUTOMATIC
Automatic mode for pond or pool floor cleaning
0 = OFF
Appliance is switched off.
= MANUAL
Continuous operation as wet/dry suction cleaner.
5. Usage as pond sludge suction cleaner, type 5360 (⌦A/D)
▶ Ensure that the appliance is switched off. Switch c in position (0) = OFF.
▶ Never use the appliance without the appropriate filter.
Assembling the appliance (⌦D)
1. Open both closing brackets d on the container h and remove the motor head b.
2. Pull the blue filter foam e over the suction cage (⌦D) and put the motor head b back onto the
container h.
3. Close the appliance once again with the aid of both closing brackets d.
4. Remove the plug g on the container base.
5. Fix the outlet hose  to the container outlet and put the strainer  over the end of the outlet hose
(⌦D).
6. Put the suction hose  into the intake nozzle f on the top of the container.
7. Connect the pipe sections  (up to 4 sections) to the connection piece  according to the water
depth and put the pond suction nozzle  (used for the suction of pond sludge, plant residue etc.) on
the pipe end.
▶ Observe the max. immersion depth of 1.2 m and the max. working height of 1.5 m (⌦G).
Operation
▶ When setting up the appliance, maintain a minimum distance of 2 m to the bank or pool edge (⌦G).
▶ Ensure that there are no people in the water.
▶ Ensure that the dirty water can flow out of the outlet hose without any problems and is aimed in the
direction in which the dirty water should flow.
16