Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
STARTING THE
DISHWASHER
Care and maintenance
FILTERING
SYSTEM
The following things should be checked before starting the
dishwasher:
1
The dishwasher is level and fixed properly
There is no leakage at the connections of the conducts.
2
The wires are tightly connected
3
4
The power is turned on
5
Make sure the inlet and drain hoses are not twisted
6
All packing materials and removable printings should be taken out from
the dishwasher
The filter prevents larger remnants of food or other objects from
getting inside the pump.
The filter system consists of a coarse filter, a flat (main filter) and a micro
filter (fine filter).
1
1
Main filter
Food and soil particles trapped by this filter are pulverized by a special jet
on the spray arm and washed down to drain.
2
Fine filter
This filter holds soil and food residue in the sump area and
prevents it from being deposited on the dishes during a wash cycle.
3
Course filter
Larger items, such as pieces of bone or glass, that could block the drain
are trapped in the coarse filter. To remove the items caught by the filter,
gently squeeze the tap on the top of this filter and lift it out.
FILTER ASSEMBLY
The filter efficiently removes food particles from the wash water, allowing it
to be recycled throughout a cycle. For best performance and results, the
filter assembly must be regularly cleaned. For this reason, it is a good
idea to remove the larger food particles trapped in the filter after each
wash cycle by rinsing the filter and cup under running water. To remove
the filter assembly, pull upward on the cup handle in the upward direction.
Note: It is recommended that you remove and rinse the filters after
each wash cycle.
17
3
2
Publicité
Table des Matières
