SEVERIN HS 0704 Mode D'emploi page 11

∙ Caution: The trimming blade is
extremely sharp; to prevent injuries,
ensure that at all times during use the
blade does not touch the skin.
∙ Use only original accessory parts; the
use of any attachments other than those
provided by the manufacturer may be
hazardous to the user.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Charging process
∙ Before using the appliance for the fi rst
time the battery must be fully charged
for a period of approximately 12 hours.
However, the appliance can remain
on charge for a longer period without
damage or danger.
∙ Should you experience a considerable
decrease in trimming performance,
switch off the appliance and recharge
the battery. The hair trimmer may also
be used by means of the adaptor. In
this case, however, the battery must
be briefl y charged for approximately 10
minutes. The charging process starts
only once the unit is switched off and is
visible by the charge indicator.
∙ With the appliance switched off, insert
the connecting plug of the adaptor into
the corresponding jack on the main unit.
∙ Insert the adaptor into a suitable wall
socket. The charging process begins
automatically and is shown by the
charge indicator on the appliance. The
indicator remains lit as long as the
charging base is connected to the mains
power.
∙ The charging process only starts if the
unit has been switched off.
∙ Once the charging process is complete,
always remove the adaptor from the wall
socket fi rst before disconnecting the
plug from the appliance.
∙ Whilst charging, the transformer within
the adaptor will become warm. This is
perfectly normal and safe and does not
indicate a malfunction of any kind.
∙ If the appliance has not been used for
a long period of time, the capacity of
the battery may decrease by a certain
amount. However, full capacity will
be restored after several charging/
discharging cycles.
Operation
Adjusting the cutting length
The push-on attachment combs allow for
adjusting the cutting length and are fi tted
over the trimming comb. The combs have
the following sizes: 3 mm, 6 mm, 9 mm
and 12 mm. The thinning head is useful for
thinning out the hair. Unlock and remove
the attachment after use.
11