Description Of The Device; Main Features Of This Device; Technical Data; Operating Instructions - Hydas 4687.1.00 Mode D'emploi

Coussin chauffant mobile pour le cou avec piles
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11

3 | Description of the device

Neck/Back Heat Pad
1
Connecting cable
2
3
Pocket for battery compartment
Closure magnets
4
Controller and Lithium Ion rechargeable battery
5
Light Emitting Diodes (LEDs)
6
[Start/Stop] button
7
Charger
8

3.1 | Main features of this device

• Extra–soft plush synthetic
• Appealing design
• The added warmth in the cervical area can help to ease tension
• It has 4 levels of heat

3.2 | Technical data

Model:
Mains adaptor:
Input voltage:
Power:
Material:
Weight:
Dimensions:

4 | Operating instructions

• If it is used for another purpose or operated incorrectly, no liability for possible damages can be accepted.
• If this device is stored near freezing, allow it to acclimate to room temperature before use.
a
Please charge the battery fully before using the device for the first time. To accomplish this, plug the charger
into a power mains and connect with the controller/battery and allow charging for 3-4 hours. The extent of the
charge is indicated by a red LED on the controller. The indicator light will turn green once charge is complete.
Afterwards: Remove charger.
b
Connect the cable of the warming cushion with the controller.
The device is now ready to be used.
c
Depress the [Start/Stop]-button for 2 seconds.
Select the desired level of warmth by pressing the [Start/Stop]-button repeatedly. Green is the lowest and red
is the highest setting.
d
Place the controller in the side pocket during use.
e
The neckpillow is then placed in the neck/shoulder region. Take care to place the battery pack pocket on the
outside, away from the body.
The 3 magnets found in the carriers serve as closures. Since one carrier contains two magnets the user can
chose a tighter or looser fit.
f
To turn off the cushion, depress and hold the [Start/Stop]-button for 2 seconds. The LED which indicated the
level of warmth will turn off.
A red blinking LED light, shows a charge is required.

4.1 | Uses

• The product is supplied with power by two Lithium Ion rechargeable batteries which are integrated in the device's
controller.
• The degree of warmth can be selected in 4 levels between 38 and 55 degrees Centigrade.
• User is free to choose the time of use. It is only limited by the life of the rechargeable battery.
LH-1153
100-240 V, 50 Hz/60 Hz, 8,4 V
8,4 V
10 Watt
100 % Polyester
220 g
34 x 19 x 1,5 cm
5
6
7
4
2
8
9
1
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lh-1153

Table des Matières