Husqvarna PG 400 Petrol Manuel D'utilisation page 9

2. When the handlebar position is set, pull the handle
lock knobs up (A) and put them into idle position (B).
A
B
Handle heights
Hole position Handle height, mm/in.
Top 835/33
Center 925/36
Lower 1000/39
To adjust the frame height
The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
1. Stop the engine. Refer to
page 13 .
2. Put 1 foot on the support frame. Use your hands to
push the angle joint handle on the central hinge. At
the same time fold the handle forward to transport
position.
883 - 002 - 10.09.2020
A
B
To stop the product on
WARNING: Use 2 hands and 1 foot
when you fold the handle.
Note: Put a protection between the engine and the
electrical enclosure to prevent damage to the
product.
3. Make sure that the handle is fully folded.
4. Remove the lock knobs (A) to loosen the support
frame (B).
A
B
9