Roller Grill ELR 2 Notice D'utilisation Et D'installation page 4

Instructions manual
ELR 2-ELR 3-ELR 4
Congratulations for purchasing this top end professional equipment! You have chosen
equipment that combines optimum technical properties with extreme user comfort. We want
you to get the greatest possible satisfaction out of this equipment.
I SAFETY INSTRUCTIONS
Please comply closely with these instructions to avoid any risk of fire, electric shock, burns
or other injuries or damage. When using this equipment, comply constantly with the basic
safety precautions, for instance:
- Take into considerations the instructions, keeping them with the equipment at all
times.
- Always install the equipment in compliance with the instructions.
- Protect the equipment from sunlight, freezing and damp.
- Do not leave the equipment within reach of children.
- Make sure that only trained people use the equipment.
- Never move of the equipment when it is operating, or when the surfaces are still
hot.
- Check that the equipment is properly turned off before connecting or disconnecting
it.
- Never used equipment for other purposes than intended.
- Never touch the hot surfaces: use the handles and buttons.
- Keep the cord away from hot services.
- Confine repairs to qualified personnel only.
- Use only original spare parts.
II CONTENTS OF PARCEL
- Appliance : Electric boiling top
III CONFORMITY OF USE
Use the appliance only to cook and reheat.
IV OPERATING
Electric boiling tops are compact appliances in all stainless steel with 1 or 2 cooking areas
according the models.
- ELR 2 : 1 electric plate Ø 23 cm
- ELR 3 : 2 electric plates Ø 18 cm
- ELR 4 : 2 electric plates Ø 23 cm
Features of the appliance are composed of 1 or 2 electric plates, 1 or 2 commutators and 1
or 2 pilot lights.
The temperature of the plate is regulated thanks to the commutator.
V OPERATION / HANDLING
a) Installation / Assembly :
- Remove the protective film of the device during the unpacking.
- Place the equipment on a stable and heating resistant surface.
- Never place the appliance near to a wall or a partition made with combustible
materials even if it is covered with a good insulating material.
- A distance of 10 cm from the partition or the wall is considered enough.
b) Initial starting up :
Connecting the equipment:
- Make sure that the voltage and frequency of the electrical system comply with the
values indicated on the nameplate.
- Always check that the electric power supply cable or plug are free of damage.
- Remove the flange to pay out the entire length of the cord and feed it through the
square hole then close it before inserting the plug into the socket.
- Connect to the electric power supply cable to a socket with a protection wire.
- The salamander is now connected.
NB: To connect the appliance to a socket without any earth wire protection, or to connect
directly to the electrical system, entrust a qualified electrician making the connection