Cameo Light OPUS S5 Manuel D'utilisation page 9

NETWORK SETTINGS (Network)
Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the Control menu and
press ENTER. Using the UP and DOWN buttons, now select the "Network" menu option and confirm via ENTER. Network settings information
can be found in the following table. Confirm all network settings changes via ENTER.
Network
Network Activate / deactivate network input
Input
Protocol Network protocol
Address Universe 1 - 256,
configure IP address and subnet mask
DMX OUT Output network signal via DMX OUT
W-DMX SETTINGS (Wireless)
Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the Control menu and
press ENTER. Using the UP and DOWN buttons, now select the "Mode" menu option and confirm via ENTER. W-DMX settings information
can be found in the following table. Confirm all changes made to the settings via ENTER.
Wireless
W-DMX OFF
ON
Operating Receiver
(currently in beta)
Transmitter
Transmitting G3
(currently in beta)
G4S
Link Link
UnLink
Receive Reset NO
YES
OFF
ON
ArtNET
sACN
Universe
000 - 255
IP address
IP Subnet Mask
OFF
ON
Deactivate W-DMX
Activate W-DMX
W-DMX module configured as receiver
W-DMX module configured as transmitter
G3 transmission standard
G4S transmission standard
Link with W-DMX devices. W-DMX must be active for all devices and the link with a transmit-
ter must be suspended (Receive Reset)
Unlink all devices
Do not suspend link with a transmitter
Suspend link with a transmitter
Network input deactivated
Network input activated
ArtNet protocol
sACN protocol
000 to 255. Change value via LEFT and RIGHT,
confirm via ENTER.
Select Block via LEFT and RIGHT, change value
via UP and DOWN, confirm with ENTER.
Select Block via LEFT and RIGHT, change value
via UP and DOWN, confirm with ENTER.
Do not output signal
Output signal
9