System Settings (Settings) - Cameo Light OPUS S5 Manuel D'utilisation

SYSTEM SETTINGS (Settings)

Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the System Settings
menu and press ENTER.
This will take you to the submenu for setting the submenu options, see table (select via UP and DOWN, confirm via ENTER, change status via
UP and DOWN, confirm via ENTER):
Settings (bold = factory setting)
Display Display settings
DMX Fail Operating mode for DMX
signal interruption
Dimmer Curve Select the dimmer curve
LED Frequency Sets the LED PWM frequency
Reverse OFF
ON
Backlight OFF
ON
Black
Hold
Auto
Linear
Exponential
Logarithmic
S-curve
650Hz, 1530Hz,
3600Hz, 12KHz,
25KHz
Display does not rotate
Display rotates by 180° (when installed
overhead)
Deactivates display backlight after approx. 30
seconds of inactivity
Display backlight permanently on
activates Blackout
Last command is held
Activates Auto mode
The light intensity climbs linearly with the DMX
value
The light intensity can be set finely in the lower
DMX value range and roughly in the upper DMX
value range
The light intensity can be set roughly in the lower
DMX value range and finely in the upper DMX
value range
The light intensity can be set finely in the lower
and upper DMX value ranges and roughly in the
medium DMX value range
11