Cleaning And Care - Sibir GSN 20010 Mode D'emploi

Cleaning and care

For hygienic reasons the appliance
(including exterior and interior
accessories) should be cleaned
regularly(at least every two months).
Warning!
The appliance must not be connected to
the mains during cleaning as there is a
danger of electrical shock! Before
cleaning switch the appliance off and
remove the plug from the mains socket.
Exterior cleaning
Wipe the control panel with a clean,
soft cloth.
Spray water on to the cleaning cloth
●
instead of spraying directly on the
surface of the appliance. This helps
ensure an even distribution of
moisture to the surface.
Clean the doors, handles and
●
cabinet surfaces with a mild detergent
and then wiped dry with a soft cloth.
Caution!
Don't use sharp objects as they are
likely to scratch the surface.
Don't use Thinner, Cardetergent,
Clorox, ethereal oil, abrasive
cleansers or organic solvent such as
Benzene for cleaning. They may
damage the surface of the appliance
and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean
when food stocks are low. Wipe the
inside of the freezer with a weak
solution of bicarbonate of soda, and
then rinse with warm water using a
wrung-out sponge or cloth. Wipe
completely dry before replacing the
shelves and drawers. Thoroughly dry
all surfaces and removable parts
before putting them back into place.
Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment's interior
walls if the freezer door is opened
frequently or keep to open too long. lf
the frost is too thick, choose a time
when the freezer is nearly empty and
proceed as follow:
1. Remove existing food and
accessories baskets, unplug the
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
process.
2. When defrosting is completed, clean
your freezer as described above.
Caution!
Do not use sharp objects to remove
frost from the freezer compartment.
Only after the interiors completely dry
should the appliance be switched back
on and plugged back into the mains
socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution!
Only after the door seals are
completely dry should the appliance
be powered on.
16